RAPiD Design(inCAD Components) Support

About file saving

• 4-1How can I add a specific string before or after the file name?
• 4-2How can I change the file name?
• 4-3How can I specify the file save location?
• 4-4When I make changes to dimensions and specifications in RAPiD Design(inCAD Components), will the original file be overwritten with the edited file?
• 4-5IHow can I save the file even though the part is a nonstandard state?
• 4-6Can I use "Pack & Go"?
• 4-7What is a file with the name "BaseModel~"?
• 4-8How can I use the same component in a different size?

About technical information

• 4-9How can I refer to the technical information required for selection?

About mates and constraints

• 4-10When mates and constraint components are edited in RAPiD Design(inCAD Components), are the mates and constraints transferred?
• 4-11Can I save components imported with mates and constraints separately with RAPiD Design(inCAD Components)?

About assembly

• 4-12Can specifications and dimensions be changed in the assembly file?
• 4-13How do I save a part or assembly file?

About configuration

• 4-14Can configurations be added?

About performance (operating speed)

• 4-15What is a suppressed state folder on the component tree?